How to setup AWS Network Load Balancer

Updated 19 November 2019

INTRODUCTION

 

A Network Load Balancer functions at the fourth layer of the Open Systems Interconnection (OSI) model. It can handle millions of requests per second. After the load balancer receives a connection request, it selects a target from the target group for the default rule. It attempts to open a TCP connection to the selected target on the port specified in the listener configuration.

 

 

STEPS TO SETUP A NETWORK LOAD BALANCER

 

Step 1:

Create two EC2 instances.

 

Step 2:

Now that EC2 instances are created install Apache web server on both of them.

Execute the following commands on both your instances to install Apache:

This should give you an output of status showing active.

 

Step 3:

Now when you visit the public IP of your instances you should see a page that says “Welcome to Apache”. Since we need to differentiate between the two servers, let us change the display to “Welcome to Apache – Server1” and on the other to “Welcome to Apache – Server2”.

Go to the directory:

Change the H1 tag from “Welcome to Apache” to “Welcome to Apache – Server1” on one instance and “Welcome to Apache – Server2” on the other.

 

Step 4:

Create a Network Load Balancer.

In the navigation pane, under LOAD BALANCING, choose load balancer. Choose create load balancer. On the Select Load Balancer type page, choose Create Network Load Balancer.

 

Step 5:

Configure the load balancer , type the name. For Scheme either select Internet-facing or Internal. In this case, I’ve chosen internet-facing. Internet-facing basically routes requests from clients to the target over the internet.

For Listeners, the default is to accept TCP traffic on port 80. In case you want to add another listener, you can choose Add Listener.

 

Step 6:

For configuring the Availability Zone, select the VPC that you’ve used to create your EC2 instances. If you’ve created your instances in different Availability Zones, then select those availability zones and subnet for that particular Availability Zones.

 

Step 7:

Select on Next: Configure Security Settings. You’ll see a warning as shown in the picture below. But it’s just a warning and you can ignore it.

In my case I am allowing TCP traffic on port 80. You can also allow traffic on TLS  port 443 to get a secure TCP connection and accordingly security settings will be configured.

 

Step 8:

For Target Group, keep the default setting new target group. For Name, type in the name.

Set Protocol and Port as required.

 

Keep the health checks with the default settings.

 

 

Step 9:

Click on Next: Register Targets

 

 

Register your instances with the target group and click on Next: Review your Load Balancer and then finally click on Create.

 

 

Step 10:

Click on Create, you’ll see that your Load Balancer is getting provisioned.

Now copy your Load Balancer’s DNS Name and paste it on a browser. The apache web page will be displayed.

The traffic will be handled by this network load balancer and will be distributed accordingly on both EC2 instances.

 

In case of any help or query, please contact us or raise a ticket.

Category(s) AWS
author
. . .

Leave a Comment

Your email address will not be published. Required fields are marked*


Be the first to comment.

Start a Project




    Message Sent!

    If you have more details or questions, you can reply to the received confirmation email.

    Back to Home